ME-430 INTRODUCTION TO COMPUTER AIDED DESIGNTORSIONAL ANALYSIS Using Pro/MECHANICA Pro/ENGINEER

Chia sẻ: Ut Phuong | Ngày: | Loại File: PDF | Số trang:30

0
109
lượt xem
47
download

ME-430 INTRODUCTION TO COMPUTER AIDED DESIGNTORSIONAL ANALYSIS Using Pro/MECHANICA Pro/ENGINEER

Mô tả tài liệu
  Download Vui lòng tải xuống để xem tài liệu đầy đủ

ME-430 INTRODUCTION TO COMPUTER AIDED DESIGN TORSIONAL ANALYSIS Using Pro/MECHANICA Pro/ENGINEER Wildfire 2.0 Dr. Herli Surjanhata The U-Joint shown in the figure below is made of steel. A torsion load of 10,000 INLB is uniformly applied over the top portion surface of the U-Joint. Determine the von Mises stresses, and maximum deflection under the given torsion load and boundary conditions. Check the convergence of your analysis. Step 1: Using Pro/ENGINEER, create a base feature as shown in the Figure below. It is done by extruding both sides the section shown with 2 inches blind depth. Create two rounds with R = 1 inch on...

Chủ đề:
Lưu

Nội dung Text: ME-430 INTRODUCTION TO COMPUTER AIDED DESIGNTORSIONAL ANALYSIS Using Pro/MECHANICA Pro/ENGINEER

Đồng bộ tài khoản