Nghệ thuật xếp hình:buck_the_bunny

Chia sẻ: Phong Thinh | Ngày: | Loại File: PDF | Số trang:2

0
206
lượt xem
20
download

Nghệ thuật xếp hình:buck_the_bunny

Mô tả tài liệu
  Download Vui lòng tải xuống để xem tài liệu đầy đủ

Nghệ thuật xếp hình: buck_the_bunny tài liệu rất có ích, nó giúp bạn nâng cao kỹ năng gấp tất cả mọi thứ bằng giấy. Bạn có thể gấp thành thạo những gì bạn thích cho riêng mình và cho bạn bè bạn.

Chủ đề:
Lưu

Nội dung Text: Nghệ thuật xếp hình:buck_the_bunny

  1. Buck The Bunny By Perry Bailey c 1998/1999 1 3 2 1 1 1 Take a dollar bill or a piece of paper ONE Reverse fold the entire bill out around the same dimensions, fold it 1 1 side of the WB base. in half the long way, then unfold. I am using a dollar bill, starting front Make a Water bomb base while folding side up crease it then turn it over. model in half. 5 4 6 1 1 Inside reverse fold the length Reverse fold in both corners, of the bill back from about the (one to a side). Reverse fold the bottom flap up half way mark of the top or bottom to form front paws, Make a Rabbits of the WB base. ear fold on each side of the head. 7 8 Body not shown head and front Body not shown only here. head and front only here. Still in enlarged mode, Reverse fold the front to make a nose, the top part of the nose will co-operated if you force it to, much like a small child or an ex- spouse. Do an uneven double rabbits This is shown enlarge to make ear fold along the lines shown to finish it possible to see the fold lines. the ears. Then we shrink the picture Squash down the ears, on both back down. sides. 9 1/3 1/3 1/3 10 11 1 1/3 1/3 1/3 Now crimp fold the rear part of the bill We make an uneven rabbits ear You should come out to get excess paper up inside of from about 1/3 from the front on top, something like this. to about 1/3 from the back on the bottom. the model, do both sides. Now we need to work inside the model so the next view is interior of the model.
  2. 12 13 This is how it should look after our thinning the model out with the preceding fold. Now do a double inside reverse fold to form the haunches. Swivel fold up the legs 14 on each side. I used the back of the bill to give you helpful reference points. 15 Crimp fold the head downwards, so it is even on both sides. Then open up the model to lock the head in to place. (See next diagram) 16 This is inside the model and magnified, to lock the head in to place just use a simple valley fold on the tip of the crimped material. Then you are done! Just for continuity here is the finished model still in the attitude you started with. While I designed it to sit up, it can go on all fours. With any luck at all your rabbits will all look a little It just might tend to have the different, each time you make it! Almost all the nose a little close to the ground. folds can be altered to make each bunny unique.
Đồng bộ tài khoản