Nghệ thuật xếp hình Nhật Bản:hexring_2

Chia sẻ: Minh Tuan | Ngày: | Loại File: PDF | Số trang:3

1
38
lượt xem
4
download

Nghệ thuật xếp hình Nhật Bản:hexring_2

Mô tả tài liệu
  Download Vui lòng tải xuống để xem tài liệu đầy đủ

Nghệ thuật xếp hình: hexring_2. Tài liệu rất có ích, nó giúp bạn nâng cao kỹ năng gấp tất cả mọi thứ bằng giấy. Bạn có thể gấp thành thạo những gì bạn thích cho riêng mình và cho bạn bè bạn.

Chủ đề:
Lưu

Nội dung Text: Nghệ thuật xếp hình Nhật Bản:hexring_2

  1. $ Hexagon Ring Copyright 1998-99 Stephen Hecht. All Rights Reserved A dollar bill results in a hexagon 19mm to a side, and 38mm across. The effect of the model depends on the “old” paper money’s centered portrait, but as the old one-dollar bills won’t be replaced for at least 5 years, it will maintain at least that much currency. A C D B B 1. Begin with bill “heads-up”. 2. Pivot on A, bring B to center- 3. Join B and D with a valley- Crease as shown. Try to line C, unfold. Extend crease crease. keep middle creases out of C to meet new crease, if the portrait. Turn over. necessary. A 4. Pivot on A, bring top-left edge to 60-degree line, unfold. 5. Bring down lightly. Repeat below. Again, extend 6. Mountain-fold on 1/4-line. middle crease to meet new creases, if necessary. 7. Bring diagonal edge to top 8 . Repeat 5-7 below, and 9. Creasing complete. edge, crease where shown, twice on the left. and unfold completely.
  2. $ Hexagon Ring (continued) Copyright 1998-99 Stephen Hecht. All Rights Reserved 10. Collapse on existing 11. Swivel. Repeat above. 12. Spread-squash. creases. The longer Temporarily unfolding the horizontal creases must be previous step may facilitate. reversed. 10-12 OPTIONAL -- thinner band OPTIONAL 13. Like so. Repeat 10-12 on other end of bill. 14. Closed-sink halfway. (Note slight curvature near 15. Wrap to the inside. the middle.) Then swing sunken flap upwards. OPTIONAL OPTIONAL OPTIONAL 16. Valley to center-line (This 17. Swing down the sink from 18. Repeat 14-17 on the is 2-ply, so beware of drift). step 14, and tuck the edge you 3 other places. Results of Slight spread-squash needed just valley-folded into it. Slight these optional steps not towards middle of model. adjustment may be needed reflected in remaining near middle. illustrations.
  3. $ Hexagon Ring (continued) Copyright 1998-99 Stephen Hecht. All Rights Reserved 19. Sink corners at 2/3, on 21. Curve ends towards existing creases. 20. Tuck left flap inside right. each other. Do the opposite below. 22. Interlock ends of bands and adjust to desired tightness. (The thinner band 23. Finished. Slight curving of the technique has more layers, and the hexagon needed before wearing. interlocking method is a bit more complex.)
Đồng bộ tài khoản