Xem 1-20 trên 21 kết quả Inductor
  • Design of Inductors and High Frequency Transformers presents of calculation of inductors; calculation of the wire; calculation of High Frequency Transformers; calculation of the winding conductors.

    pdf6p khoaicuto 19-03-2015 4 3   Download

  • This book is mainly intended for designers and users of magnetic components in power electronics. It can also be used for didactical purposes. Magnetic components such as inductors and transformers constitute together with the control and the semiconductor components, the main parts in the design of power electronic converters. Some experience teaches that the design of the magnetic parts is still often done by trial and error. This can be explained by a (too) long working-in time for designing inductors and transformers.

    pdf456p nguyenthai_thinh 16-03-2013 78 34   Download

  • Tuyển tập báo cáo các nghiên cứu khoa học quốc tế ngành hóa học dành cho các bạn yêu hóa học tham khảo đề tài: Low temperature fired Ni-Cu-Zn ferrite nanoparticles through auto combustion method for multilayer chip inductor applications

    pdf31p sting07 16-02-2012 16 2   Download

  • Resistors in an AC circuit, capacitors in an AC circuit, inductors in an AC circuit, the RLC series circuit, power in an ac circuit, resonance in a series rlc circuit, the transformer,... As the main contents of the document "Alternating current circuits and electromagnetic waves". Invite you to consult.

    pdf33p cau301 21-10-2015 5 2   Download

  • (BQ) Part 1 book "Engineering circuit analysis" has contents: Basic components and electric circuits, voltage and current laws, basic nodal and mesh analysis, handy circuit analysis techniques, the operational amplifier, capacitors and inductors, basic RL and RC circuits, the RLC circuit,...and other content.

    pdf396p bautroibinhyen20 06-03-2017 5 1   Download

  • Lecture Electric circuit theory: Capacitor and inductor include all of the following: Capacitor, inductor, the Dc steady state. Inviting ypu refer lecture for more details.

    pdf12p youcanletgo_04 17-01-2016 5 0   Download

  • (BQ) Part 1 book "Engineering circuit analysis" has contents: Basic components and electric circuits, voltage and current laws, basic nodal and mesh analysis, handy circuit analysis techniques, the operational amplifier, capacitors and inductors, basic RL and RC circuits, the RLC circuit,...and other content.

    pdf441p bautroibinhyen20 06-03-2017 3 0   Download

  • Electronics may be defined as the science and technology of electronic devices and systems.Electronic devices are primarily non-linear devices such as diodes and transistors and in general integrated circuits (ICs) in which small signals (voltages and currents) are applied to them. Of course, electronic systems may include resistors, capacitors and inductors as well.

    ppt58p taphikhanh 18-12-2009 182 97   Download

  • Equivalent circuit device models are critical for the accurate design and modelling of RF components including transistors, diodes, resistors, capacitors and inductors. This chapter will begin with the bipolar transistor starting with the basic T and then the π model at low frequencies and then show how this can be extended for use at high frequencies. These models should be as simple as possible to enable a clear understanding of the operation of the circuit and allow easy analysis. They should then be extendible to include the parasitic components to enable accurate optimisation....

    pdf62p doroxon 16-08-2010 179 67   Download

  • Thay đổi chuyển hóa Nhiều thuốc bị chuyển hóa ở gan do các enzym chuyển hóa thuốc của microsom ga n (xin xem phần dược động học). Những enzym này lại có thể được tăng hoạt tính (gây cảm ứng) hoặc bị ức chế bởi các thuốc khác. Do đó sẽ làm giảm t/2, giảm hiệu lực (nếu là thuốc gây cảm ứng enzym) hoặc làm tăng t/2, tăng hiệu lực (nếu là thuốc ức chế enzy m) của thuốcdùng cùng.

    pdf5p thaythuocvn 26-10-2010 128 38   Download

  • SPICE (Simulation Program for Integrated Circuits Emphasis) is a general purpose analog circuit simulator that is used to verify circuit designs and to predict the circuit behavior. • PSpice is a PC version of SPICE and HSpice is a version that runs on workstations and larger computers. • PSpice has analog and digital libraries of standard components (such as NAND, NOR, flip-flops, and other digital gates, op amps, etc) which makes it a useful tool for a wide range of analog and digital applications....

    ppt25p rain105 01-11-2012 56 24   Download

  • Various Components and Their System Parameters An RF and microwave system consists of many different components connected by transmission lines. In general, the components are classified as passive components and active (or solid-state) components. The passive components include resistors, capacitors, inductors, connectors, transitions, transformers, tapers, tuners, matching networks, couplers, hybrids, power dividers=combiners, baluns, resonators, filters, multiplexers, isolators, circulators, delay lines, and antennas. ...

    pdf38p vaseline 30-08-2010 62 19   Download

  • A buck converter is a step-down DC to DC converter. Its design is similar to the step-up boost converter, and like the boost converter it is a switched-mode power supply that uses two switches (a transistor and a diode), an inductor and a capacitor. The simplest way to reduce the voltage of a DC supply is to use a linear regulator (such as a 7805), but linear regulators waste energy as they operate by dissipating excess power as heat.

    doc12p ducnguyen_nd 07-09-2012 87 19   Download

  • Power Conversion Circuits and Diodes 6.002 Fall 2000 Lecture 24 1 .Power Conversion Circuits (PCC) PCC 110V 60Hz + – 5V DC solar cells, battery 3V DC PCC + – 5V DC DC-to-DC UP converter Power efficiency of converter important, so use lots of devices: MOSFET switches, clock circuits, inductors, capacitors, op amps, diodes R Reading: Chapter 16 and 4.4 of A & L. 6.002 Fall 2000 Lecture 24 2 .First, let’s look at the diode iD + vD – v ⎛ VD ⎞ ⎜ e T − 1⎟ iD = I S ⎜ ⎟ ⎠ ⎝ I S = 10 −12 A VT = 0.

    pdf20p thachcotran 04-02-2010 88 15   Download

  • TWO-PORT NETWORKS Electronic circuits are frequently needed for processing a given electrical signal to extract the desired information or characteristics. This includes boosting the strength of a weak signal or ®ltering out certain frequency bands and so forth. Most of these circuits can be modeled as a black box that contains a linear network comprising resistors, inductors, capacitors, and dependent sources. Thus, it may include electronic devices but not the independent sources. Further, it has four terminals, two for input and the other two for output of the signal....

    pdf52p vaseline 30-08-2010 51 13   Download

  • where Z = impedance, W; R = resistance, W; L = inductance, H; XL = inductive reactance, W; XC = capacitive reactance, W; and q = phase angle, degrees, by which current leads voltage in a capacitive circuit or lags voltage in an inductive circuit (0° indicates an in-phase condition). Resonant Frequency When an inductor and capacitor are connected in series or parallel, they form a resonant circuit. The resonant frequency can be determined from the equation

    pdf20p balanghuyen 13-01-2010 93 12   Download

  • This book covers fundamental aspects of electric circuits that form the core of many engineering disciplines. In particular, basic circuit elements and their characteristics are presented when connected in an electric network. In addition, techniques to analyse and solve electric circuits are explained in a simple manner and examples are shown to demonstrate each strategy. DC as well as AC circuit analysis is provided with a brief account of filters in the end.

    pdf87p sn_buon 29-11-2012 27 7   Download

  • Chương 2 Cấu kiện thụ động, cùng tìm hiểu chương học với các nội dụng sau: Điện trở (Resistor); Tụ điện (Capacitor); Cuộn cảm (Inductor); Biến áp (Transformer ).

    pdf54p canhdangxuan 03-04-2014 24 6   Download

  • ACTIVE FILTER DESIGN WITH NOMINAL ERROR Although electric wave filters have been used for over a century since Marconi’s radio experiments, the identification of stable and ideally terminated filter networks has occurred only during the past 35 years. Filtering at the lower instrumentation frequencies has always been a problem with passive filters because the required L and C values are larger and inductor losses appreciable.

    pdf28p huggoo 20-08-2010 44 5   Download

  • Air gap in coupled inductor, 502 in flyback transformer, 503 in inductor, 464-466, 498, 505, 509 in transformer, 469 AL (mH/1000 turns), 509 American wire gauge (AWG) data, 755-756 design examples, 527, 531 Amorphous alloys, 473 AmpereÕs law, 457-458 Amp-second balance (see Capacitor charge balance) Apparent power, 550 Artificial ramp circuit, 415 effect on CPM boost low-harmonic rectifier, 637-639 effect on line-to-output transfer function of CCM buck, 437-438 effect on small-signal CCM models, 428-438 effect on small-signal DCM models, 438-447 effect on stability of CPM controllers, 414-...

    pdf20p longmontran 14-01-2010 75 3   Download


Đồng bộ tài khoản