Xem 1-5 trên 5 kết quả Wheel alignment
  • Tham khảo tài liệu 'thiết bị kiểm tra và chẩn đoán góc đặt bánh xe (wheel alignment)', kỹ thuật - công nghệ, cơ khí - chế tạo máy phục vụ nhu cầu học tập, nghiên cứu và làm việc hiệu quả

    pdf9p ducchi1507 28-08-2012 173 64   Download

  • Zero Camber and Positive Camber Steering axis inclinationUneven wear of tire Excess on positive side 90° Outside Excess on negative side Negative camber Centrifugal force Small positive Positive camber Straight-ahead driving camber Cornering force Centrifugal force Straight-ahead driving Large positive camber Cornering force

    pdf27p ducchi1507 28-08-2012 77 13   Download

  • Diagnosis Technician Suspension and Steering Wheel Alignment Description Description Camber Steering axis inclination Caster Toe Turning radius (1/1) Diagnosis Technician Suspension and Steering Wheel Alignment Camber Description 0 Negative Positive Camber C b Camber 90° • Uneven wear of tire Excess on positive side Outside Excess on negative side Outside Inside Inside (1/1) Diagnosis Technician Suspension and Steering Wheel Alignment Camber Negative Camber Camber thrust Negative camber Inside Outside Inside Positive camber Outside Load Load O Camber th...

    pdf27p tieutaithan 15-11-2010 145 56   Download

  • FRONT SUSPENSION • STRUCTURAL VIEW 4x2 TENSION ROD UPPER ARM STABILIZER LOWER ARM TORSION BAR APRING 4x4 SHOCK ABSORBER TORSION BAR SPRING STABILIZER UPPER ARM SHOCK ABSORBER LOWER ARM REAR SUSPENSION • STRUCTURAL VIEW 4X4 SHOCK ABSORBER LEAF SPRING 4X4 HEIGHT ADJUSTMENT • FRONT ONLY VEHICLE HEIGHT 4x2 4x4 ANCHOR BOLT FRONT WHEEL ALIGNMENT • CAMBER AND CASTER SHIM FOR CAMBER ADJUSTMENT SHIM FOR CASTER ADJUSTMENT FRONT SHIM WHEEL ALIGNMENT • MAXIMUM STEERING ANGLE 4x2 4x4 4 4 ADJUSTING BOLT ...

    pdf6p tieutaithan 15-11-2010 84 28   Download

  • To make sure the second straw is parallel to the first, make a jig (a device that holds component parts in their correct position) that is as wide as the distance you want between the two straws. A two-by-four-inch piece of lumber would work. Align one side of the two-by-four with the glued straw, and glue the second straw aligned with the other edge of the board. Cut two dowels three-quarters of an inch longer that the length of the straw bear- ings. Sand the cut ends and attach one wheel. In most cases the dowel will make a tight fit with the wheel and you won’t...

    pdf8p nhacnenzingme 23-03-2013 18 3   Download

Đồng bộ tài khoản