intTypePromotion=1
ADSENSE

An investigation on effects of wire-EDM machining parameters on surface roughness of newly developed DC53 die steel

Chia sẻ: Đăng Xuân Phương | Ngày: | Loại File: PDF | Số trang:4

26
lượt xem
1
download
 
  Download Vui lòng tải xuống để xem tài liệu đầy đủ

(BQ) This paper investigated the effects of machining parameters on surface roughness of wire EDMed DC53 die steel. The investigated machining parameters were pulse-on time, pulse-off time, pulse-peak current, and wire tension. Analysis of variance (ANOVA) technique was used to find out the parameters affecting the surface roughness. Assumptions of ANOVA were discussed and then examined through residual analysis. Quantitative testing methods on residual analysis were employed in place of the typical qualitative testing techniques. Results from ANOVA show that pulse-on time and pulse-peak current are significant variables to surface roughness of wire-EDMed DC53 die steel. The surface roughness of test specimen increased as these two variables increased.

Chủ đề:
Lưu

Nội dung Text: An investigation on effects of wire-EDM machining parameters on surface roughness of newly developed DC53 die steel

ADSENSE

CÓ THỂ BẠN MUỐN DOWNLOAD

 

Đồng bộ tài khoản
2=>2