Đ THI SKILL CCNA1 Ề
CCNA1 SKILL BASED EXAMINATION
Duration: 80 minuten
Configuration requirements : (8 marks)
1. Calculating the subnet addressing for the lab using the VLSM technique and note all information needed on the topology.
2. In each LAN, configure the second usable host address for PC1 and the last usable host address for PC2.
3. Perform Basic Router Configurations all Routers.
4. Enable routing on R1, R2, R3 and R4 by using the static routing protocol.
Challenge questions : (2 marks)
1. How many bits need to be borrowed if the Classfull subneting technique is used ? __4 bit__
Subnet 1: 172.30.16.0/20 ---> 172.30.31.255/20
Subnet 2: 172.30.32.0/20 ---> 172.30.47.255/20
Subnet 3: 172.30.48.0/20 ---> 172.30.63.255/20
2. How many addresses for hosts will the network 124.12.4.0/22 provide?
A. 510
B. 512
C. 1022
C. 1024
D. 2046
E. 2048
CCNA1 SKILL BASED EXAMINATION
Duration: 80 minuten
Configuration requirements: (8 marks)
1. Calculating the subnet addressing for the lab using the VLSM technique and note all information needed on the topology.
2. In each LAN, configure the second usable host address for PC1 and the last usable host address for PC2.
3. Perform Basic Router Configurations all Routers.
4. Enable routing on R1, R2, R3 and R4 by using the static routing protocol.
Challenge questions: (2 marks)
1. How many bits need to be borrowed if the Classfull subneting technique is used ? __4 bit__
Subnet 1: 172.25.16.0/20 ---> 172.25.31.255/20
Subnet 2: 172.25.32.0/20 ---> 172.25.47.255/20
Subnet 3: 172.25.48.0/20 ---> 172.25.63.255/20
2. How many addresses for hosts will the network 124.12.4.0/21 provide?
A. 510
B. 512
C. 1022
D. 1024
E. 2046
F. 2048
CCNA1 SKILL BASED EXAMINATION
Duration: 80 minutes
Configuration requirements: (8 marks)
1. Calculating the subnet addressing for the lab using the VLSM technique and note all information needed on the topology.
2. In each LAN, configure the second usable host address for PC1 and the last usable host address for PC2.
3. Perform Basic Router Configurations all Routers.
4. Enable routing on R1, R2, R3 and R4 by using the static routing protocol.
Challenge questions: (2 marks)