REPORT  DESIGN AND MANUFACTURING  PLASTIC INJECTION MOLD

HOT RUNNER

I. CONSTITUTE

The structure of a channel hot Hot Runner

Plastic Materials in  the distribution  channels are kept in  the molten state  during spraying

HOT RUNNER

CONSTITUTE

Those of Hot Runner System suite

1. Equipment heating of raw sugar: Heater

2. The temperature control device: thermocouple, Controller

3. Insulation Division: In the mold using HRS has added insulation  (space) to prevent an increase in temperature of the mold

4. Division adjust the movement of V / cell:

Piston, V / PinVpin linear motion up and down by compressed air  pressure pushes the piston moves in the cylinder translational

Functional parts of the Hot Runner

• Silver spray stalk

• Connect with the spray nozzles.

• Closed cooling systems for  connection Flows from machine  to the nozzle.

• ­Reduced Xuatkhi necessary  pressure.

• vHELP plastic from the machine  nozzle to the manifold.

Funnel plastic • Transporting and distributing hot plastic

flow.

• Maintain a constant temperature of strong

plastic spray.

• Transmission pressure plastic line ..  1. Manifold plastic  2.Ranh 3. limit trans 4.  5. lace 6. beetles cdien  return manifold 7.HEAT or tubular 8. parts Hiet time

Nozzle • Grade plastic nozzle heater to vents.

• Maintain a constant temperature donhua while spraying.

1.Nozzle tip 2.Vongdem 3.Chot van 4.Thiet Hiet time 5.Cap resistor 6.Than Nozzle vVi bottom of the Hot  Runner System. The most important detail  vLa

mouth spray

• Providing hot resin to longkhuon.

The technical requirements of  vents: + Against freezing and interrupt the  flow of plastic.

• Maintaining paths in a cavity plastic.

• Disconnect the plastic flow.

+ No spinning or drip.

+ Minimum pressure loss.

mouth spray

Van cơ

ạ vD ng van  tệ nhi

IV. APPLICATION

• Nozzle heating and miengphun. These products have a thicker,

require more filling materials.