Trình tự câu lệnh_Command Sequence Configuration

Chia sẻ: Cx Thuan | Ngày: | Loại File: DOCX | Số trang:9

Thêm vào BST

Báo xấu

71
lượt xem 15
download

Download Vui lòng tải xuống để xem tài liệu đầy đủ

1. Loop Start give the number of repetition for command below the loop start (General - Loop Start) 2. Dial select the MS and give the destination number (Voice - Dial) 3. Synchronize to synchcronize MS before go to the next command (General - Synchronize) 4. Wait 120 wait 120s on call (General - Wait) 5. End Call (Voice - End Call) 6. Wait 15 wait 15 before call again (General - Wait) 7. Loop End (General - Loop End)

Chủ đề:

Bình luận(0) Đăng nhập để gửi bình luận!

Lưu

Nội dung Text: Trình tự câu lệnh_Command Sequence Configuration

Herewith the example of command sequence in TEMS 6.1.4 I. Voice Call CS i.e “120/15″ means 120 second on call then call end, 15 second wait and then call again. 1. Loop Start give the number of repetition for command below the loop start (General -> Loop Start) 2. Dial select the MS and give the destination number (Voice -> Dial) 3. Synchronize to synchcronize MS before go to the next command (General -> Synchronize)
4. Wait 120 wait 120s on call (General -> Wait) 5. End Call (Voice -> End Call) 6. Wait 15 wait 15 before call again (General -> Wait) 7. Loop End (General -> Loop End) II. Video Call CS In general cs for video call is same as voice call, but in video call in dial command we must add “v”. i.e Loop Start Dial v081384760975 Wait 120 End Call Wait 15 Loop End III. Packet Service (PS) Test This is the example cs for PS test
All equipment that we use in PS Test is DC (Data Cable). In command dial up : DT *99***1# orinaica ************ means DT is dial up connection that we should made first in network connection setup account for this connection (fill username and password : orinaica and ***********)
select modem that we want to use in PS Test
give additional command (at command, “orinaica.wordpress.com” is the apn name that will use in connection) *99***1# is the dial number for dial up connection
This is details to make cs in PS Test
Data Services Dial Up (Connect -> Dial Up) Phonebook Entry use DT (dial up connection that we’ve made before) Phone Number : Dial Up number for dial up connection Username : username of account network connection Password : password of account network connection FTP Get (Session -> FTP -> Get) Equipment Name : Select equipment name Source File : Select file that will “get” from ftp server Target File : Destination folder where file will be place PASV : Disable Remote Address : IP Address of the FTP Server
Username : Username for log in to FTP Server Password : Password for log in to FTP Server