Analysis of tool wear

In this research, the influence of the cutting parameters including cutting speed, feed rate and cutting depth on the flank wear and surface roughness was analyzed by using 2k experimental model with some center points. The results investigated that the feed rate is the most significant parameter effecting on the surface roughness in the machining process and the cutting speed strongly affects on the flank wear in the hard turning of sintered tungsten carbide using CBN inserts.

7p nguaconbaynhay12 13-06-2021 13 1   Download

This research focus on to presents of the MQL parameters optimization approach in which the multi-response outputs based on Taguchi's L9 orthogonal array method is used. During the turning AISI-1045 steel, the cutting temperature, the maximum of tool wear, and the surface roughness were measured. The MQL parameters which are ratio of soluble lubricant and water, pressure of spray head, flow volume of emulsion was simultaneously optimized by taking the multi-response outputs using Taguchi based grey relational analysis (GRA) into consideration.

11p trinhthamhodang9 04-12-2020 19 3   Download

The results show that the tool wear was influenced principally by the cutting time and in the second level by the cutting tool hardness. On the other hand, cutting time was the dominant factor affecting workpiece surface roughness followed by cutting speed. Finally, the multiple response optimizations of tool wear and surface roughness were carried out using the desirability function approach (DFA).

12p toritori 11-05-2020 15 0   Download

(BQ) Electrical discharge machining (EDM) is a widespread process which works very effectively in machining of difficult-to-cut materials and alloys in die and aerospace industries with high dimensional accuracies. However, this capability could be deteriorated due to electrode wear leading to decrease of process productivity. In this study, the effect of machining parameters of EDM process including on-time, current, voltage, the engaging time between workpiece and electrode, and pre-EDM roughing on electrode wear were experimentally investigated.

4p xuanphuongdhts 27-03-2017 44 2   Download

(BQ) In this study, the effect of machining parameters of EDM process including on-time, current, voltage, the engaging time between workpiece and electrode, and pre-EDM roughing on electrode wear were experimentally investigated. Main effects of factors and interactions were considered in this paper and regression equation was derived. A L50 (21 × 511) Taguchi’s standard orthogonal array was employed as experimental design. Copper was used as electrode to machine the hot work tool steel 1.2714, which is widely used to make forging dies and mandrels.

4p xuanphuongdhts 27-03-2017 40 2   Download