Energy dispersive spectroscopy

In this study, spinel ferrite nanoparticles CoFe2-xLaxO4 (x = 0, 0.025, and 0.05) were successfully synthesized via a simple co-precipitation method using a 5% NaOH solution as a precipitating agent. The physicochemical properties of the materials, annealed at 850 °C for one hour, were characterized using powder X-ray diffraction (PXRD), energy-dispersive X-ray spectroscopy (EDX), transmission electron microscopy (TEM), and vibrating-sample magnetometry (VSM) at room temperature.

10p viling 11-10-2024 2 1   Download

The single phase of Mn0.5Fe2.5O4 spinel crystals was prepared by the microemulsion method with the oil phase is DGDE (diethylene glycol diethyl ether). The characteristics of the materials have been determined by the X-ray diffraction (XRD), Energy-dispersive X-ray spectroscopy (EDX), Scanning electron microscopy (SEM) and Brunaure-Emmet-Teller (BET) nitrogen adsorption and desorption, Vibration sampling magnetometer (VSM), Fourier transform infrared spectroscopy (FTIR).

7p vikwong 29-09-2024 3 1   Download

Novel g-C3N4/InVO4 materials were synthesized by a fabricated via hydrothermal and heating methods. The physicochemical properties of the photocatalysts were investigated by X-ray diffraction (XRD), infrared spectroscopy (IR), Photoluminescence spectroscopy (PL), UV-Vis diffuse reflectance spectroscopy (UV-Vis-DRS) and Energy dispersive X-ray spectroscopy (EDX).

5p vikwong 29-09-2024 5 1   Download

This article reported the preparation of Nano CeO2 by acid method from Binh Dinh monazite ore. Obtained CeO2 was examined by the method of X-ray diffraction (XRD), scanning electron microscopy (SEM) and transmission electron microscopy (TEM), energy-dispersive X-ray spectroscopy (EDS), specific surface area analysis by Brunauer-Emmet-Teller (BET) method, UVVIS.

5p vikwong 29-09-2024 2 1   Download

In this study, in-situ method was applied for synthesizing silver-doped graphene oxide (Ag/GO). The material was extensively characterized by X-ray diffraction, Transmission electron microscopy, Scanning electron microscope, Raman spectroscopy, energy-dispersive X-ray spectroscopy, and UV-Vis spectroscopy.

6p vikwong 29-09-2024 4 1   Download

WO3/Ag3VO4 photocatalyst was synthesized for benefiting the visible region of solar spectrum for degradation of antibiotic pollutant. The prepared catalyst was characterized by using scanning electron microscope (SEM), X-ray diffraction (XRD), infrared spectroscopy (IR) and energy-dispersive X-ray spectroscopy (EDX).

6p vikwong 29-09-2024 3 1   Download

A series of Mg-Cu-Al hydrotalcite/chitosan materials have been synthesized via a co-precipitation method, in which chitosan is synthesized from chitin extraction from waste shrimp shells. The obtained solids were characterized by XRD, BET, EDX, IR techniques. The materials have a well crystallized hydrotalcite structure and medium surface area.

5p vikwong 29-09-2024 3 1   Download

In this study, the Cu-TiO2-SBA-16 photocatalytic materials were successfully prepared by direct hydrothermal synthesis method. The products were characterized by X-ray diffraction (XRD), Ultraviolet– Visible Diffuse Reflectance Spectroscopy (UV-Vis DRS), energy dispersive X-ray (EDX), transmission electron microscopy (TEM), N2 adsorption–desorption isotherms, X-ray photoelectron spectroscopy (XPS) methods.

6p vikwong 29-09-2024 3 1   Download

CuO nanoparticles were synthesized by alcohol-assisted hydrothermal method at various pH values, using sodium hydroxide as a precursor for pH control. The chemical composition, morphological and structural properties of the obtained CuO nanoparticles were investigated by the Raman and energy-dispersive X-ray spectroscopies, the field-emission scanning electron microscopy, and the X-ray diffraction.

12p dianmotminh02 03-05-2024 3 1   Download

The objectives of this research work are: Study the clay intercalation by organic dye and develop a process to produce nanoclay-dye pigment with better stability and good performance; Conduct structural characterization to verify the level of intercalation and stability of clay-dye pigment by using X-Ray diffraction (XRD) and Transmission Electron Microscopy (TEM); Investigate the thermal stability of clay dye pigment using Thermo Gravimetric Analysis (TGA) to reveal the effect of dye intercalation into the clay on improving thermal stability of organic dye; Compound the clay- pigment with ...

141p runthenight07 01-03-2023 5 3   Download

Nghiên cứu này thực hiện nhằm đánh giá khả năng xử lý metylen xanh trong nước tổng hợp bằng phương pháp xúc tác quang sử dụng Ag-TiO2-SiO2 phủ lên bi thủy tinh chạy dưới ánh sáng mặt trời. Đặc trưng hình thái và thành phần của vật liệu trước và sau xử lý được phân tích bằng phương pháp ảnh từ kính hiển vi điện tử quét (Scanning Electro Microscope - SEM) và phổ tán sắc năng lượng tia X (Energy-dispersive X-ray spectroscopy - EDS).

12p vimississippi2711 07-12-2020 44 2   Download

In this study, SnO2:Ni2 powders with dopant contents ranging from 0.0 to 12 mol% were synthesized by sol-gel method. The samples were characterized by X-ray diffraction (XRD) Raman spectroscopy, energy-dispersive X-ray spectrometer (EDS) and photoluminescense (PL) spectra.

8p tamynhan6 14-09-2020 30 2   Download

In the present study, GNPs/Ti-Fe binary oxide composites were synthesized from ilmenite of Central Viet Nam using hydrothermal method. The effect of amount of Fe on the morphology, structure and photocatalytic performance of prepared materials were characterized by scanning electron microscopy, transmission electron microscopy, X-ray diffraction, UV–VIS Diffuse Reflectance spectrophotometer, Energy-dispersive X-ray spectroscopy and BET techniques.

10p abcxyz123_02 03-03-2020 18 3   Download

Thiol-functionalized SBA-15 silicas have been directly synthesized by cocondensation of tetraethyl orthosilicate (TEOS) and 3-(trimethoxysilyl)-1-propanolthiol (TSPT) under hydrothermal condition. Mesoporous structure was obtained after the surfactant removal by Soxhlet and reflux ethanol extraction. These materials were characterized by means of powder X-ray diffraction, isotherms of nitrogen adsorption/desorption, thermal analysis, infrared spectroscopy and energy-dispersive X-ray spectroscopy.

9p thiendiadaodien_9 04-03-2019 24 0   Download

Influences of additives saccarin, thioure and natrilaurylsulphate on the electrodeposition process of the alloy FeCoNi were investigated using polarization curves and energy disperse spectroscopy (EDS). Results show that saccarin increases the anomalous ratio of the couples Fe/Ni (TFe/Ni) and Co/Ni (TCo/Ni) while thioure influences on TFe/Ni, TCo/Ni slightly and natrilaurylsulphate decreases TFe/Ni, TCo/Ni remarkably. The results can be explained by the different adsorption processes of the additives.

4p uocvong02 24-09-2015 24 2   Download