Portland cement

This paper presents the results of laboratory experiments to determine the influence of 4 different fillers (including conventional stone powder, Portland cement, rice husk ash, and fly ash) on some mechanical properties of asphalt concrete with Dmax of 12.5 (AC12.5).

8p viengfa 28-10-2024 1 1   Download

High-volume fly ash mortar is considered a "green" material, a sustainable development solution for the construction industry, in which the fly ash replacement Portland cement content is over 50%. However, this material has the major disadvantage of slow strength development, especially at an early age, which limits its applicability.

10p vibecca 01-10-2024 0 0   Download

In this research, the performance of a cementless eco-binder, a mixture of waste materials including slag, circulating fluidized bed combustion ash (CFA), and rice husk ash (RHA) was investigated, in which CFA acted as an activator.

13p vifilm 24-09-2024 2 1   Download

The paper investigates the flexural performance of reinforced concrete beams in which fly ash from Vinh Tan power station was used to replace original Portland cement in the proportions of 0%, 10%, 20% and 40% by weight.

13p vifilm 24-09-2024 1 1   Download

Drying shrinkage is the main cause of early age cracking of concrete and mortar. A wide range of research has been conducted to reduce the drying shrinkage, including using fibres or chemical admixtures. This paper investigated the effect of shrinkage reducing admixture on the flexural strength, compressive strength, drying shrinkage, water absorption and porosity of mortar.

13p vifilm 24-09-2024 2 1   Download

The research in the field of cementitious materials has brought towards many non-traditional binder systems. One of these systems, a ternary binder composed of calcium aluminate cement (CAC), ordinary Portland cement (OPC), and calcium sulfate (C$Hx), called ettringite binder, offers a possibility of very rapid development in mechanical strength.

6p viyoko 24-09-2024 2 1   Download

This study attempts to utilize cold-bonded fly ash based artificial lightweight aggregate (ALWA) and retrieved unground rice husk ash (URHA) as internal curing (IC) agents for improving performance of typical supersulfated cement (SSC) mortar fabricated with ternary mixture of 85% slag, 10% gypsum, and only 5% blended Portland cement (PCB).

17p vifaye 20-09-2024 2 1   Download

Treating dredged sediment is a complex processing and ongoing challenge. To utilize dredged sediment for the landfill or construction purposes, a material fabricated from a mixture of dredged sediment, Portland cement, and fly ash, was cured under room temperature and hydrothermal condition at 180 °C and 0.9 MPa pressure for 16 hours. The response surface methodology was used to evaluate the compressive strength of the material, with the range of factors investigated being the dredged sediments/solid ratio (0.3 - 0.9), cement/fly ash ratio (2 - 4), and water/solid ratio (0.45 - 0.55).

13p xuanphongdacy06 18-09-2024 2 1   Download

(NB) Giáo trình Kỹ thuật sản xuất xi măng poóc lăng (Cement Portland) với các nội dung thành phần khoáng và hóa của clinker xi măng poóc lăng; đặc trưng các thành phần clinker xi măng poóc lăng; tính toán phối liệu sản xuất clinker xi măng poóc lăng; công nghệ sản xuất xi măng poóc lăng; quá trình rắn chắc của xi măng pooc lăng; cấu trúc, tính chất của hồ và đá xi măng; tính chất cơ lý của xi măng.

79p nguathienthan7 27-08-2020 180 19   Download

This technique allows saving Portland cement without reducing significantly the concrete strength. The ability to obtain ultra-fine mineral fillers from industrial by-products with high specific surface area appears with grinding technology development.

7p lucastanguyen 01-06-2020 22 1   Download

Portland cement concrete (PCC) / asphalt concrete (AC) bonded components are seen in both conventional pavement structures as well as overlays. Due to the environmental and traffic loads, cracks occur at the interface of the PCC and AC layers and finally, may propagate through the interface or one of the layers.

14p tohitohi 19-05-2020 18 2   Download

This paper deals with using stainless steel reducing slag (SSRS), a byproduct generated from stainless steel making process, as a cement substitute in production of soil-based controlled low-strength material (CLSM). In the CLSM mixture, surplus soil and river sand were blended well together with a sand-soil proportion of 6:4 by volume in order to produce fine aggregate. Totally, twelve mixtures were prepared for experiment when we changed in turn percentages of Portland cement replacement with SSRS of 0%, 10%, 20%, and 30% by weight and the water-to-binder ratio of 3.4, 3.6, and 3.8.

5p cathydoll5 26-02-2019 21 0   Download

The reactions form chains and rings of alumino-silicate networks in geopolymeric structures. The raw materials used for geopolymerization normally contain high SiO2 and Al2O3 in the chemical compositions such as meta-kaoline, rice husk ash, fly ash, bottom ash, blast furnace slag, red mud, and others. The geopolymer-based material has potentials to replace Ordinary Portland Cement (OPC)-based materials in the future because of its lower energy consumption, minimal CO2 emissions and lower production cost as it utilizes industrial waste resources.

8p quaymax4 05-09-2018 28 0   Download

Concrete can be classified as composite material and that is a combination of different components which improve their performance properties. In general case binder component which can be in hard crystalline or amorphous state is considered as the matrix of composite material. In concrete matrix phase the grains of aggregates (dispersed phase) are uniformly distributed.

179p beobobeo 01-08-2012 83 14   Download