intTypePromotion=1
zunia.vn Tuyển sinh 2024 dành cho Gen-Z zunia.vn zunia.vn
ADSENSE

Turbine operation

Xem 1-20 trên 36 kết quả Turbine operation
  • Part 1 book "Power plant equipment operation and maintenance guide" includes content: Gas turbine applications in power stations, gas turbine protective systems, and tests; steam turbine selection for combined cycle power systems; steam turbine maintenance; frequently asked questions about turbine generator balancing, vibration analysis, and maintenance; features enhancing the reliability and maintainability of steam turbines;... and other contents.

    pdf388p dianmotminh03 17-06-2024 2 0   Download

  • Part 2 book "Renewable energy and power supply challenges for rural regions" includes content: The exploitation of wind systems in rural electrical network; factors affecting the power efficient operation of wind diesel complexes; strategies for protection systems of wind turbines with doubly fed induction generator; energy and water saving on the pumping stations of karshi main canal; improving the power quality of rural consumers by means of electricity cost adjustment; resonant power system for electric transport.

    pdf236p dianmotminh03 11-06-2024 12 1   Download

  • Part 1 book "Steam turbines for modern Fossil-Fuel power plants" includes content: Start up technologies as applied to different start up systems, start up instructions for steam turbine power units and their improvement, scheduled and unscheduled load changes within and beyond the governed range, cycling operation and its influence on turbine performances,... and other contents.

    pdf291p dianmotminh00 22-04-2024 3 3   Download

  • Part 1 book "Thermal power plant - Design and operation" includes content: Steam power plant cycles, steam generators, fuels and combustion, pulverized coal fired boilers, fluidized bed combustion boilers, steam turbines, gas turbine and heat recovery steam generator.

    pdf296p dianmotminh00 22-04-2024 6 3   Download

  • Part 2 book "Fish protection technologies and fish ways for downstream migration" includes content: Fishways for downstream migration, fish friendly turbines, fish friendly operational management, species and development specific requirements for fish protection and downstream passage, habitat measures, open questions and knowledge deficits.

    pdf110p muasambanhan01 11-12-2023 5 3   Download

  • This specification covers the determination of heat stability of steam turbine shafts and rotor forgings to ensure stability at operating temperature. This specification is not ordinarily applicable to generator rotor forgings.

    pdf3p hth_hn_vn 10-12-2023 7 3   Download

  • This paper focuses on evaluating the formation and development of cavitation by time of reversible impeller of PaT when operating in pump mode by numerical simulation with ANSYS-Fluent software.

    pdf3p vilucius 15-03-2023 5 2   Download

  • The main aims of this study are to: understand the phenomena of isolated mixing regions (IMRs) in Newtonian fluids agitated in mechanically stirred vessels, in particular, the formation of core torus, using experimental studies; investigate the behavior of IMRs structures by manipulating the operating variables such as impeller rotational speed and direction, as well as geometrical variables such as impeller types and baffle location; investigate the temporal chaotic mixing using different speed modulation protocols.

    pdf94p runthenight07 01-03-2023 7 2   Download

  • This paper presents the simulation results of using a static synchronous compensator (STATCOM) to improve damping of a grid connected wind power system (WPS). The operating performance of the studied WPS is simulated by an equivalent doubly fed induction generator (DFIG) driven by an equivalent wind turbine (WT).

    pdf4p vijaguar 16-11-2022 11 1   Download

  • (BQ) Ebook Aircraft powerplants (8th edition): Part 2 includes the following content: Turbine-engine lubricants and lubricating systems; ignition and starting systems of gas-turbine engines; turbofan, turboprop, and turboshaft engines; gas-turbine operation, inspection, troubleshooting, maintenance, and overhaul; propeller theory, nomenclature, and operation; turbopropellers and control systems; propeller installation, inspection, and maintenance; engine indicating, warning, and control systems.

    pdf370p runordie6 10-08-2022 7 2   Download

  • Lecture Power system operation and control - Lesson 25: Renewable energy systems, distribution systems, smart grid provide students with knowledge about environmental aspects of wind energy, human aesthetics; shadow flicker is more of an issue in high latitude countries since a lower sun casts longer shadows; wind turbines and radar; types of wind turbines for power flow and transient stability;...

    ppt42p hanthienngao 15-04-2022 11 1   Download

  • In this paper, the application of a series grid-side converter (SEGSC) connected to a wind-turbine-driven doubly fed induction generator (DFIG) is introduced. The setup allows the wind turbine system an uninterruptible fault ride-through of voltage dips. The SEGSC can compensate the faulty line voltage, while the DFIG wind turbine can continue its nominal operation as demanded in actual grid codes.

    pdf11p kequaidan8 02-11-2020 14 1   Download

  • The experiment results reveal suitability of using a mono block centrifugal pump in hydro turbine mode. The results confirm that the pump in hydro turbine mode operate at higher heads and discharge as compared to the pump mode operation. BEP (best efficiency point) for the pump in hydro turbine mode is lower than in pump mode operation. Correlations proposed by earlier researchers for performance prediction of pump in hydro turbine mode are also tested.

    pdf12p cleopatrahuynh 01-06-2020 17 0   Download

  • The results of simulated transients for three typical PWR accidents are presented: a turbine trip with station blackout, a large break loss of coolant accident and a small break loss of coolant accident. The analyses show that the safety criteria are respected and that the reactor quickly reaches a safe shutdown state without operator action and external power.

    pdf10p christabelhuynh 31-05-2020 27 0   Download

  • This paper presents the modeling and simulation of wind turbine driven by doubly-fed induction generator which feeds ac power to the distribution network. A stator flux oriented vector control is used for the variable speed doubly-fed induction generator operation. By controlling the generator excitation current the amplitude of the stator EMF is adjusted equal to the amplitude of the grid voltage.

    pdf9p lucastanguyen 28-05-2020 24 1   Download

  • In this paper, an artificial neural network (ANN) based algorithm is proposed as a solution to this problem. This algorithm is used to estimate wind turbine systems operational state and reliability.

    pdf8p kelseynguyen 28-05-2020 14 0   Download

  • In advanced modern turbines, the temperature of the turbine's first blade row which is called the turbine's hot part, increases almost as 1000℃. These blades must operate for long periods of time.

    pdf12p tohitohi 19-05-2020 34 2   Download

  • This paper introduces the development of a transient monitoring system to detect the early stage of a transient, to identify the type of the transient scenario, and to inform an operator with the remaining time to turbine trip when there is no operator's relevant control. This study focused on the transients originating from a secondary system in nuclear power plants (NPPs), because the secondary system was recognized to be a more dominant factor to make unplanned turbine-generator trips which can ultimately result in reactor trips.

    pdf8p minhxaminhyeu5 30-06-2019 21 1   Download

  • (bq) part 2 book "centrifugal pumps" has contents: numerical flow calculations, hydraulic forces, noise and vibrations, operation of centrifugal pump, turbine operation, general characteristics,...and other contents.

    pdf526p bautroibinhyen19 24-02-2017 42 5   Download

  • (bq) part 2 book "centrifugal pumps" has contents: hydraulic forces, noise and vibrations, operation of centrifugal pumps, turbine operation, general characteristics, influence of the medium on performance, selection of materials exposed to high flowvelocities, pump selection and quality considerations.

    pdf526p bautroibinhyen18 23-02-2017 40 5   Download

CHỦ ĐỀ BẠN MUỐN TÌM

TOP DOWNLOAD
ADSENSE

nocache searchPhinxDoc

 

Đồng bộ tài khoản
2=>2