The Plastic Product P4
94
lượt xem 23
download
lượt xem 23
download
Download
Vui lòng tải xuống để xem tài liệu đầy đủ
General Appearance of the Product Parting Line Flash Good molds have venting around most of, if not the whole length of the parting line. As long as the stack and the vents are designed properly, there should never be flash on the parting line. If flashing does occur despite a properly designed and built mold, there could be a number of other causes: The selected molding machine has not enough clamp force (tonnage) for the projected area of the cavity and the required injection pressure or was not adjusted properly. ...
Chủ đề:
Bình luận(0) Đăng nhập để gửi bình luận!
CÓ THỂ BẠN MUỐN DOWNLOAD