Conducting polyme

This article conducts an exhaustive investigation into the utilization of machine learning (ML) methods for forecasting the maximum load capacity (MLC) of circular reinforced concrete columns (CRCC) using Fiber-Reinforced Polymer (FRP). Extreme Gradient Boosting (XGB) algorithm is combined with novel metaheuristic algorithms, namely Sailfish Optimizer and Aquila Optimizer, to fine-tune its hyperparameters.

18p viengfa 28-10-2024 2 2   Download

In this study, Zinc oxide (ZnO) nanoparticles with a size of about 50 - 70 nm were green-synthesized using tea leaves and ZnO/Polypyrrole (ZnO/Ppy) nanocomposites were obtained by ultrasonic-assisted chemical polymerization method using pyrrole monomer and the nanoparticles. The characterization of the materials is conducted using several analytical techniques, including Field Emission Scanning Electron Microscopy (FESEM) and X-Ray Diffraction (XRD) and Ultraviolet visible spectrum (UV-Vis).

11p xuanphongdacy06 18-09-2024 2 1   Download

In the present study, we have made an attempt to prepare complexed PVA-PVP-KNO3-BaTiO3 blend composite polymer electrolyte membranes composed of potassium nitrate (KNO3) as salt and BaTiO3 of various concentrations as filler and studied their properties. The advantages of addition the fillers are the increase in ionic conductivity at room temperatures and the improvement of the stability at the interface with electrodes.

12p dianmotminh02 03-05-2024 11 2   Download

In this thesis atomistic level modelling is conducted to investigate the design of an environmentally adaptable self-cleaning polymer paint coating that incorporates biomimetics to remain clean in various environmental setting. This work will be used to aid in the development of stay-clean polymer paint coating.

116p runthenight07 01-03-2023 7 3   Download

The objectives of this research work are: Study the clay intercalation by organic dye and develop a process to produce nanoclay-dye pigment with better stability and good performance; Conduct structural characterization to verify the level of intercalation and stability of clay-dye pigment by using X-Ray diffraction (XRD) and Transmission Electron Microscopy (TEM); Investigate the thermal stability of clay dye pigment using Thermo Gravimetric Analysis (TGA) to reveal the effect of dye intercalation into the clay on improving thermal stability of organic dye; Compound the clay- pigment with ...

141p runthenight07 01-03-2023 5 3   Download

The goal of the thesis: The thesis examined the effect of different nanostructured morphologies in conductive polymer films (PPy, PANi) on NH3 gas sensitivity. The thesis fabricated the nanostructured hybrid films between metal oxide (NiO) and conductive polymer (PPy) successfully and examined the NH3 gas sensitivity properties of the NiO / PPy hybrid film.

28p extraenglish 24-05-2021 26 3   Download

The thesis focuses on studying MA operating in the frequency region of 2-18 GHz in 2 main approaches: Asymmetric and isotropic MA with multi-peak; broadening the absorption range by integrating conductive polymer; the content of the thesis is based on a consistent combination of theoretical models and simulation software.

16p capheviahe27 23-02-2021 8 3   Download

Study on modification/functionalization of conductive polymers using nanostructured materials (CNTs, Fe3O4 nanoparticles and Graphene) to develop the electrochemical biosensor and apply this biosensor in biomedical and environmental analysis.

27p trinhthamhodang7 31-08-2020 26 2   Download

The present work deals with a simple approach which predicts the optimum setting of process parameters of drilling operation on Polymer Based Glass Fiber (PBGF) composite.

9p lucastanguyen 01-06-2020 19 3   Download

In the current context of eco-pollution, the substitute of conventional plastics with bioplastics is a big confront. On account of that, a non-growth associated PHB production study was conducted using Zobellella species under submerged fermentation process. As a result, Zobellella species showed the ability to accumulate 2.2g/L of PHB at pH 8. 0, temperature 37oC, salt concentration 2% in modified growth medium containing vitamins. Then, primary structural characterization of extracted polymer was conducted by FTIR analysis. The high intense peak was obtained at 1720.

7p nguaconbaynhay6 24-06-2020 38 3   Download

An experimental analysis of the effect of gamma and X-ray irradiation with dose rate 0.25 -6mSv/h on low-density polyethylene (LDPE) and PMMA samples is presented. The focus of attention is on their DC conductivity as a dielectric of a capacitor.

10p tohitohi 19-05-2020 31 2   Download

In this study, the impact response of glass/epoxy laminates interleaved by Polycaprolactone (PCL) nanofibers is considered. PCL is a thermoplastic polymer, which is a good choice for toughening epoxy-based composite. The impact tests were conducted on curved laminates and under 24 and 36J.

6p tohitohi 19-05-2020 23 1   Download

In this research, a number of studies had been conducted on the thermal decomposition and fire behavior of kevlar fiber reinforced polymer composites (CP-KUFR). Unsaturated polyester (UPE) was mixed with fire retardant additives including antimony trioxide (Sb2O3), aluminum hydroxide Al(OH)3, chlorinated paraffin (CPs).

6p viengland2711 23-07-2019 11 0   Download

The objectives of the thesis: Fabrication of diaphragm sensing material based on phenyl conductive polymer has stability and high sensitivity with heavy metal cations, which is used to identify and analyze heavy metal traces in water. Mời các bạn tham khảo!

26p xacxuoc4321 08-07-2019 48 6   Download

The objective of the research is to assess the reinforcement possibility of CNT in the rubber substrate and blend rubber in order to create rubber nanocomposite materials with a high mechanical properties, sustainability in the solvent, and suitable electrical conductivity.

28p change04 08-06-2016 44 4   Download

Presently, in mineral industry of Vietnam 2 types of spiral separators are employed: (i) 1200 mm-diameter type made of unplastized PVC (type A) and (ii) 600 mm-diameter type made of polymer composite (PC) and surface layer is chloroprene rubber (type B). In practice it has proven that type B has conductivity considerably higher than type A and easy movement resulting from smaller size.

5p uocvong04 24-09-2015 39 2   Download

The electrooxidation of 5-hydroxy-1,4-naphthoquinone (JUG) in organic media leads to conducting polymer film on glassy and Pt electrodes. The IR ex situ, IR in situ (MIRFTIRS) during the film formation, XPS studies indicate that electropolymerization occurs via the OH group while quinone group on the other ring remains intact and shows a very good electro activity and stability in different media, particularly in aqueous, biocompatible one.

5p uocvong03 24-09-2015 56 3   Download

The conducting polymer poly(5-hydroxy-1,4-naphthoquinone-co-5-hydroxy-3-acetic acid-1,4- naphthoquinone) with electroactive quinone group was investigated by Electrochemical Impedance Spectroscopy (EIS) in aqueous medium. The evaluations of parameters of equivalent circuit in term of applied potential were considered. The simulated EIS data presented a good agreement with the results obtained by other electrochemical methods.

5p uocvong03 24-09-2015 63 3   Download

The development of concept in structural morphology lets description the location of nickel nanoclusters in conductive organic polymers, which may be a new kind of structure in conductive organic polymer composites family. As a new route, such the development was supported by electrochemical two-pot process, on which polianiline containing nanoclusters of nickel incorporated in layer by layer were prepared, in H2SO4 0.1 M solutions. The presence of nickel nanoclusters in polymer matrix and the changes in morphology were confirmed by SEM/EDS

5p uocvong01 24-09-2015 41 2   Download

This study is focused on the synthesis of a polyindole doped by indole-3 butyric acid (PI-IBA). IR analyze indicated that the linkage positions of indole involves the position 2 and 3 of the monomer and the insertion of IBA in the polymer backbone. Polyindole IBA doped was incorporated into epoxy resin for protection anticorrosion of carbon steel. The electrochemical impedance measurements show a significantly improvement of protective properties in presence of PI-IBA in comparison with pure epoxy and epoxy containing polyindole coating.

6p uocvong01 24-09-2015 49 4   Download