High temperature materials

The aim of this Master of Engineering (MEng) - Aerospace thesis is to study the structural response and failure of aerospace grade composites during exposure to fire. Key aspects of the research are to analyse the thermal and mechanical responses of laminates and sandwich composites in high temperature and fire environments, which result in softening and structural failure. The research is concentrated on carbon/epoxy laminates and sandwich composites, which are the most common composite materials used in aerospace structures.

209p runthenight05 01-03-2023 10 3   Download

Research institutes and also industrial companies in Czech Republic are involved in High Temperature Gas Cooled Reactor (HTGR) program and activities related to the study of advanced materials and HTGR technologies. These activities are supported by EC (within international projects, e.g. FP7-ARCHER, ALLIANCE, GoFastR can be mentioned) and also by Technology Agency of Czech Republic.

7p christabelhuynh 30-05-2020 36 1   Download

Study of high temperature steam oxidation kinetics during the high temperature oxidation was carried out on the sponge base E110 cladding tubes material in the temperature range 600–1300 °C. The oxidation kinetics derived from the weight gain measurements showed a parabolic rate law for temperatures 1100 °C and higher only.

6p christabelhuynh 30-05-2020 12 1   Download

The article discusses the strength of concrete and other brittle materials in the case of nonuniform biaxial type of compression (σ1 > σ2 > 0) and triaxial compression of σ1 > σ2 = σ3 > 0  type (it was assumed that σ> 0 corresponds to compression). I

6p tohitohi 19-05-2020 17 0   Download

Metal cutting puts extreme demands on the tool and tool material through conditions of high forces, high contact pressures, high temperatures, and intense chemical attack by difficult to cut work materials. In addition, the tool geometry and cutting conditions in terms of sharp edges, cyclic engagement and presence of cutting fluid will add to the severity. Most often cutting tools are used close to their ultimate resistance against these loads, especially to the limiting thermal and mechanical stresses. ...

14p cuunien 20-12-2010 116 17   Download