Oil recovery processes

Xem 1-14 trên 14 kết quả Oil recovery processes
  • Worldwide, crude oil demand is unceasingly increasing. As a response, Enhanced Oil Recovery (EOR) processes have re‐gained interest from the research and development phases to the oilfield EOR implementation stage. This renewed interest has been also furthered by the current high oil price environment, the maturation of oilfields worldwide, and few new‐well discoveries. Concurrently, environmental concerns and public pressure related to crude oil pollution control and remediation of oilcontaminated sites are becoming greater than ever....

    pdf330p wqwqwqwqwq 09-07-2012 100 21   Download

  • This book is intended for graduate students, researchers, and reservoir engineers who want to understand the mathematical description of the chromatographic mechanisms that are the basis for gas injection processes for enhanced oil recovery. Readers familiar with the calculus of partial derivatives and properties of matrices (including eigenvalues and eigenvectors) should have no trouble following the mathematical development of the material presented.

    pdf293p chipmoon 19-07-2012 60 12   Download

  • The matched reservoir model with reservoir and fluid properties have been used to implement sensitivity analysis, the result indicated that there is significantly oil incremental and water cut reduction by GAGDapplication. Many different scenarios have run to find the optimal reservoir performance through GAGD process. Among these runs, the optimal scenario, which has distinct target, requires high levels of gas injection rate to attain the maximum cumulative oil production.

    pdf8p hulk1234 01-06-2018 11 0   Download

  • In this study, the kinetic models of steam distillation of orange (Citrus sinensis (L.) Osbeck), pomelo (Citrus grandis L.), and lemongrass (Cymbopogoncitratus) for the recovery of essential oils were developed. The model parameters wereestimated based on experimental data and comprehensive kinetic mechanismsof the solid-liquid extraction process.

    pdf8p dannisa 16-12-2018 17 1   Download

  • PRODUCE-ECONOMICALLY- PART OF OIL LEFT BY CONVENTIONAL RECOVERY METHODS – Improvement of displacement efficiency decreasing Sorw miscible or near miscible gas injection chemical flood-surfactants increasing gravity forces oil vaporization – Improvement of volumetric sweep efficiency lowering mobility ratio by increasing w chemical flood - polymers reducing o thermal flood

    pdf118p minhhieu2105 19-06-2013 55 8   Download

  • A study on the fish oil extraction from yellowfin tuna heads by hydrolysis method using Protamex enzyme was carried out. The parameters of hydrolysis process, fishoil yield and chemical quality of tuna head oil were determined. The study results showed that a considerable amount of oil can be extracted from yellowfin tuna heads.

    pdf8p viryucha2711 24-04-2019 6 0   Download

  • There is increasing political and environmental pressure on industry to clean up the water which it uses in many processes, and to re-use this water where possible. This cleaning is done using specially-developed industrial membranes and this book covers the types and design of membranes, how they work and in which industries they are used. Special attention is paid to the textile, food/ beverage, pharmaceutical, oil and pulp and paper industries where such membranes are in regular use.

    pdf318p chipmoon 27-08-2012 71 17   Download

  • Environment-friendly treatment of sewage sludge has become tremendously important. Conversion ofsewage sludge into energy products by environment-friendly conversion process, with its energy recovery and environmental benefits, is being paid significant attention.

    pdf8p tuananhhumg 04-11-2013 35 3   Download

  • Refinery Process Air Emissions The most significant air emission sources in oil refineries are catalytic or thermal cracking units, catalytic reformer units, sulfur recovery plants, storage vessels, fluid coking units wastewater streams, cooling towers, equipment leaks, blowdown systems, vacuum distillation units, steam boilers, process furnaces, process heaters, compressor engines, barge or ship loading and gasoline loading racks specifically located at petroleum refineries.

    pdf10p chatraqn 13-12-2012 45 1   Download

  • Source: HANDBOOK OF MECHANICAL ENGINEERING CALCULATIONS SECTION 18 ENVIRONMENTAL CONTROL AND ENERGY CONSERVATION ENVIRONMENTAL CONTAMINATION ANALYSIS AND PREVENTION 18.2 Recycle Profit Potentials in Municipal Wastes 18.2 Choice of Cleanup Technology for Contaminated Waste Sites 18.4 Cleaning Up a Contaminated Waste Site Via Bioremediation 18.10 Process and Effluent Treatment Plant Cost Estimates by Scale-Up Methods 18.16 Work Required to Clean Oil-Polluted Beaches 18.73 Sizing Explosion Vents for Industrial Structures 18.75 Industrial Building Ventilation for Environmental Safety 18.

    pdf164p medinova 26-10-2010 104 42   Download

  • that can occur during the various phases of oil and gas recovery from subsurface reservoirs including production, drilling, hydraulic fracturing, and workover operations. Formation damage assessment, control, and remediation are among the most important issues to be resolved for efficient exploitation of hydrocarbon reservoirs. Such damage is caused by various adverse processes, including chemical, physical, biological, and thermal interactions of formation and fluids, and deformation of formation under stress and fluid shear.

    pdf95p lulanphuong 19-03-2012 110 22   Download

  • High specific surface area. The amount of gas–liquid surface area per unit volume of material that is attainable in a foam is greater than that in comparable two-phase systems. This property makes gas–liquid foam particularly attractive for interphase mass transfer operations. Examples of such processes are froth flotation, in which valuable hydrophobic particles are recovered from a slurry, the recovery of oil sands, and the stripping of gases from effluent by absorption into the liquid phase....

    pdf536p namde04 02-05-2013 45 11   Download

  • Modifications of the dry-grind facility have made the recovery of corn germ possible in dry milling. Normally, neither corn germ nor any other corn fraction is separated out before becoming part of the mash; all components go through fermentation and become part of the feed coproduct, DDGS. Various modifications of the process have made it possible to recover fiber and corn germ—and thus corn oil—from both the endosperm and the peri- carp (outer covering) of the kernel.

    pdf62p loixinloi 08-05-2013 53 3   Download

  • Cogeneration is frequently defined as the sequential production of necessary heat and power (electrical or mechanical) or the recovery of low-level energy for power production. This sequential energy production yields fuel savings relative to separate energy production facilities because both the heat and power requirements are satisfied from a common/single fuel source.

    pdf37p loixinloi 08-05-2013 36 3   Download



p_strKeyword=Oil recovery processes

nocache searchPhinxDoc


Đồng bộ tài khoản