Overlap cutting points
-
This paper aims to apply a kinematic model and then propose a method for setting speeds for diamond dressing process on the current configuration of CMP tool.
8p lucastanguyen 01-06-2020 4 1 Download
-
Moving to the new panel, check measurements again before cutting pillars etc. for jointing. At this point it is probably safer to leave a "safety margin" of about 1cm (in the right direction!!) when cutting any mid-panel joints. When the panel is offered up for a trial fit and clamped correctly in place, this overlap can be marked and removed more precisely, or crimped with a flanging tool so that one panel slots under the other. Clean up all surfaces to be welded, drilling spotweld holes in the new panel if required. Refit to the vehicle and adjust so that...
16p nhacnenzingme 23-03-2013 57 5 Download