![](images/graphics/blank.gif)
Torque Angle Control
-
In this paper, the combustion phase optimization is analyzed and ignition timing of SI engines is controlled to maximize the fuel efficiency. Particularly, the optimum set point of the combustion phase and moving average based control strategy are discussed to extract information about the fuel efficiency from the combustion.
4p
vispyker
16-11-2022
11
1
Download
-
In order to obtain maximum power output of wind turbine systems, it is necessary to control the wind turbine such as pitch angles and torques by several methods. In this paper, the radial basic function (RBF) neural network is used to control the variability of blade pitch angles.
11p
cleopatrahuynh
01-06-2020
25
1
Download
-
For disadvantages of the large flux and torque ripple and current waveform distortion of Direct Torque Control (BASIC-DTC), the DTC scheme for induction motor based on torque angle closed-loop control was presented and the proposed scheme was realized with three methods of torque angle closed-loop control.
10p
vivalletta2711
11-01-2020
13
0
Download
-
Model Outline Engine Chassis Engine Chassis Body Body Electrical Steering EPS (Electric Power Steering) – Motor drives the rack directly Resolver Type R l T Torque Sensors [Specifications] Type Gear R ti (O G Ratio (Overall) ll) No. of Turns Lock to Lock Rack Stroke [mm in.
0p
tieutaithan
22-11-2010
198
70
Download
-
CHAPTER 8 GEARED SYSTEMS AND VARIABLE-SPEED MECHANISMS GEARS AND GEARING Gear tooth terminology Gears are versatile mechanical components capable of performing many different kinds of power transmission or motion control. Examples of these are • • • • Changing rotational speed. Changing rotational direction. Changing the angular orientation of rotational motion. Multiplication or division of torque or magnitude of rotation. • Converting rotational to linear motion and its reverse. • Offsetting or changing the location of rotating motion.
52p
medinova
26-10-2010
79
7
Download
-
Gears are versatile mechanical components capable of performing many different kinds of power transmission or motion control. Examples of these are • • • • Changing rotational speed. Changing rotational direction. Changing the angular orientation of rotational motion. Multiplication or division of torque or magnitude of rotation. • Converting rotational to linear motion and its reverse. • Offsetting or changing the location of rotating motion. Gear Tooth Geometry: This is determined primarily by pitch, depth, and pressure angle....
52p
phuphong
09-12-2009
109
26
Download