High temperature stress
-
In this work, the protective effect of ectoines against pH stress and high temperature has been investigated using an alkaline active xylanase from Bacillus halodurans as a model. The disaccharide, trehalose—a well-known stabiliser for biomolecules (Kaushik and Bhat 2003), has also been included in the study. The enzyme was selected as a model because it is efficiently active at high pH and is highly stable in the pH range of 5.5–10.5 at 50 °C.
8p runordie3 27-06-2022 11 2 Download
-
The article discusses the strength of concrete and other brittle materials in the case of nonuniform biaxial type of compression (σ1 > σ2 > 0) and triaxial compression of σ1 > σ2 = σ3 > 0 type (it was assumed that σ> 0 corresponds to compression). I
6p tohitohi 19-05-2020 16 0 Download
-
The present paper summaries the results from uniaxial-tension stress-controlled fatigue tests performed at different temperatures up to 650°C on Cu-Be specimens. Two geometries are considered: hourglass shaped and plates weakened by a central hole (Cu-Be alloy).
6p tohitohi 19-05-2020 8 0 Download
-
GRAS transcription factor (TF) family is unique and numerous in higher plants with diverse functions that involving in plant growth and development processes, such as gibberellin (GA) signal transduction, root development, root nodule formation, and mycorrhiza formation.
14p vishikamaru2711 29-04-2020 13 1 Download
-
We reported earlier that ectopic expression of CAP2, a single AP2 domain containing transcription activator from chickpea (Cicer arietinum)in tobacco improves growth and development, and tolerance to dehydration and salt stress, of the transgenic plants.
11p vinaphone15 25-02-2013 36 2 Download
-
Metal cutting puts extreme demands on the tool and tool material through conditions of high forces, high contact pressures, high temperatures, and intense chemical attack by difficult to cut work materials. In addition, the tool geometry and cutting conditions in terms of sharp edges, cyclic engagement and presence of cutting fluid will add to the severity. Most often cutting tools are used close to their ultimate resistance against these loads, especially to the limiting thermal and mechanical stresses. ...
14p cuunien 20-12-2010 114 17 Download