Magnetic properties

In this study, spinel ferrite nanoparticles CoFe2-xLaxO4 (x = 0, 0.025, and 0.05) were successfully synthesized via a simple co-precipitation method using a 5% NaOH solution as a precipitating agent. The physicochemical properties of the materials, annealed at 850 °C for one hour, were characterized using powder X-ray diffraction (PXRD), energy-dispersive X-ray spectroscopy (EDX), transmission electron microscopy (TEM), and vibrating-sample magnetometry (VSM) at room temperature.

10p viling 11-10-2024 1 0   Download

The single phase of Mn0.5Fe2.5O4 spinel crystals was prepared by the microemulsion method with the oil phase is DGDE (diethylene glycol diethyl ether). The characteristics of the materials have been determined by the X-ray diffraction (XRD), Energy-dispersive X-ray spectroscopy (EDX), Scanning electron microscopy (SEM) and Brunaure-Emmet-Teller (BET) nitrogen adsorption and desorption, Vibration sampling magnetometer (VSM), Fourier transform infrared spectroscopy (FTIR).

7p vikwong 29-09-2024 3 1   Download

In this report, the cold crystallization of bis[2-[(octylimino)methyl]-1-pyrenolato-N,O] copper(II) is studied and discussed using the magnetic properties, the FT-IR spectra, and thermal analyses.

6p vikwong 29-09-2024 5 1   Download

The study was performed on 25 patients diagnosed with liver tumors, assigned magnetic resonance imaging (MRI) with Primovist - a hepatospecific paramagnetic gadolinium-based contrast agent at the International Medical Center of Hue Central Hospital.

4p vinatisu 29-08-2024 3 1   Download

In this work, SrFe12O19 samples were synthesized by hydrothermal method. We systematically studied the influence of an alkaline environment (NaOH) with the molar ratio (R) of 2 , 3 and 4 on the structure, magnetic properties of SrFe12O19 particles prepared by hydrothermal method. The relation between morphology, magnetic properties and microwave absorption properties of materials have been investigated.

8p viambani 18-06-2024 2 1   Download

Harvesting microalgae by centrifugation and filtration is very costly, affecting technical and economical feasibility of downstream processing of algal biomas to bioproducts. Flocculation is a potential technique for recovery of algae biomass. Particularly, flocculation using magnetic nanoparticles offers high separation efficiency due to their high surface area and magnetic properties. I

10p dianmotminh02 03-05-2024 5 1   Download

The tectonic and structural properties of Erzurum and its surroundings have been investigated by evaluating the seismotectonic b - value, magnetic anomaly, edge detection analysis (total horizontal derivative (THDR) and tilt angle (TA)), Curie Point Depth (CPD), P-wave velocity (Vp), and Vp / Vs (S - wave velocity) ratio and by imaging the regional distributions of these parameters. For this purpose, all parameters have been combined to be able to reveal the new useful results on the study region and are presented for different locations and depths.

24p tanmocphong 29-01-2022 25 2   Download

The research objectives of the thesis: Mn-(Bi, Ga) based rare-earth-free hard magnetic materials. Soft magnetic materials of Fe-Co. Rare-earth-free hard magnetic nano composite materials of Mn-(Bi, Ga)/Fe-Co.

27p thebadguys 08-06-2021 30 5   Download

Research objectives of the thesis: Clarification influence of the elements Na, Sr and Ba substituting for La/Ca and crystal size on the magnetic properties, phase transition and magnetocaloric effects of La0,7Ca0,3MnO3 materials. Found the materials for significant mmagnetocaloric parameters have potential for applications in magnetic refrigeration.Determine the effect of replacing Sr/Ba for Ca in La0,7Ca0,3MnO3 and Co substituting for Mn in La0,7Sr0,3MnO3 on their critical behavior as well as the ferromagnetic interactions order.

31p extraenglish 24-05-2021 24 4   Download

This work aims to fabricate ferrite - (Ag, Au) hybrid nanomaterials with a SPR peak located in the near-infrared region, high magnetic/optical-to-thermal conversion and ability to contrast MRI images for both T1- and T2- weighted modes, which are strongly bactericidal and able to be applied in biomedicine.

30p capheviahe27 23-02-2021 13 3   Download

Find the optimal technology parameters and components for fabricating Fe-based nanomaterials using high-energy ball milling method; clarify the relationship between technological conditions with the structural characteristics and magnetic properties of fabricated materials; assess the applicability of Fe, Fe-Co nano materials in fabricating nanocomposite magnets and magnetic induction heating.

24p capheviahe26 25-01-2021 18 1   Download

In this paper we consider some properties of the SU(2) YangMills theory connecting with scalar o4 theory. In the case when scalar field φ is time independent, we find explicit solutions to equations of motion for corresponding o4 theory. The spatial component of the SU(2) Yang-Mills potential corresponding with this solution is like potential of point magnetic monopole.

6p tamynhan8 04-11-2020 9 1   Download

In this paper, we present the results of the study of the effect of residual La on crystal structure, magnetic properties of La1+ơFe11.05Si1.95 (ơ= 0.00; 0.03; 0.06 and 0.09) compounds. The analysis of X-ray diffractions showed that when the La content increases to 9, the structure still remains cubic in a typical NaZn13 arrangement with unchanged lattice constant (about 0.5).

6p tamynhan6 14-09-2020 28 3   Download

Influence of substitution of 3d metals for Mn on properties of La0.67Ca0.33Mn0.9 TM0.1O3 (TM = Fe, Co, Ni) compounds was studied. Ferromagnetic – paramagnetic and metals – insulator transitions were significantly affected by Mn-site substitution. However, no observable difference was found in their crystal structure from X-ray diffraction analysis. At room temperature the structure characterization of these compounds gave the single phase and structure is the distortion orthorhombic cell with space group symmetry Pnma.

12p 12120609 01-06-2020 13 2   Download

In this paper, we present the results of studying magnetic properties and magnetocaloric effect of Fe90-xPrxZr10 (x = 1, 2 and 3) rapidly quenched alloys. The alloy ribbons with thickness of about 15 µm were prepared by melt-spinning method on a single roller system. X-ray diffraction patterns of the ribbons manifest their almost amorphous structure. Thermomagnetization measurements show that the Curie temperature of the alloys can be controlled to be near room temperature by changing concentration of Pr (x).

7p abcxyz123_02 03-03-2020 22 3   Download

The Co nanowire arrays were fabricated by electrodeposition method by using the porous polycarbonate template. Study on crystallographic structure, micro structure, and the element composition confirmed the quality of the fabricated Co nanowires. SEM image shows the wires with an average diameter of 200 nm and the average length of 9 m. The magnetic properties, measured at room temperature using vibrating sample magnetometry (VSM), displays that the nanowires have anisotropic property.

7p abcxyz123_02 03-03-2020 14 3   Download

In this work, we report the effects of decomposition of MnBi low temperature phase (LTP) into Bi and Mn during low-energy ball milling (LEBM) carried out in xylene and silicon oil protection solvent environments and its influence on the magnetic properties of MnBi as-milled powders. In both solvents, by LEBM for 120 - 150 min, MnBi arc-melted and annealed alloys were ground into fine particles of 0.5 – 5 µm to increase iHc up to 5 kOe.

7p abcxyz123_02 03-03-2020 16 3   Download

In this paper, we present the effects of subtituting elements of M (Ti, Si and Nb) and annealing temperatures on the structure and magnetic properties of Co79-xZr18+x-yMyB3 alloy ribbons (x = 0 - 2, y = 0 - 4). Hard magnetic properties of the alloy ribbons can be strengthened so significantly as a coercivity of Hc > 4 kOe and maximum energy product of (BH)max > 3.5 MGOe with an appropriate concentration of Ti, Si or Nb and annealing process.

11p abcxyz123_02 03-03-2020 16 2   Download

The thesis aims to produce nanoparticles (dielectric, ferrites, ferromagnetic, metal) and their nanoparticles. Find the optimal technology process, suitable for making absorbent samples. Survey the basic properties of fabricated nanomaterials. Measuring and studying the effects of microwave absorption in magnetic-dielectric nanoparticles, absorption mechanisms and dependence of absorbing properties on the parameters of materials, thereby finding solutions Enhance absorption capacity as well as adjust absorption parameters.

28p xacxuoc4321 09-07-2019 28 4   Download

The objectives of the thesis: Manufacturing multifunctional nanoparticles including: Fe3O4 nanoparticles (magnetical properties) coated with biocompatible polymers, attaching drugs (Cur, Dox) and targeted folate factor (optical properties)) that are well dispersed in water, able to target the cancer.Experiment and evaluate the effect of the nanoparticles on cancer cell lines such as HT29; HeLa; HepG2 ... and on experimental animals.

27p xacxuoc4321 09-07-2019 62 5   Download