Temperature and irradiation

This paper proposes a method to identify the optimal operating point fora photovoltaic power system. With theinformation on the power's solar irradiance, the temperature at P-N junction, and the generated power limit, an algorithm is proposed to calculate points on the voltage-power curve based on an utterly mathematical model of the generation, iterative,and bisectional techniques.

5p viyoko 01-10-2024 2 1   Download

Polyurethane (PU) thin films quickly degrade under the presence of oxygen, vapor, temperature, and ultraviolet irradiation. Thus, efforts have been dedicated to improving the properties of PU films. This study presents a simple synthesis route to prepare PU embedded with CeO2-SiO2 nanocomposites (CS NCs).

7p vikwong 29-09-2024 5 1   Download

Thermostable and highly water-soluble polymers are essential for polymer flooding — one of the most effective methods used in the enhanced oil recovery (EOR) in hightemperature (HT) offshore reservoirs. In this research, the copolymerization reaction of acrylamide (AM) and N-vinylpyrrolidone (NVP) monomers were performed via a freeradical mechanism induced by gamma-rays (γ-rays) irradiation.

79p viabigailjohnson 10-06-2022 13 3   Download

The objective of the present work is to study the irradiation effects on third generation SiC fibers which fulfill the minimum requisites for nuclear applications, i.e. Hi-Nicalon type S, hereafter HNS, and Tyranno SA3, hereafter TSA3. With this purpose, these fibers have been ion-irradiated with 4 MeV Au ions at room temperature and increasing fluences.

9p christabelhuynh 31-05-2020 19 1   Download

An analytical and numerical solution is developed for a transient heat conduction equation in which a plane slab is heated by a bimodal distribution beam over the upper surface. In laser heat treatment of steel few methods are used to produce a wider and nearly uniform average irradiance profile.

8p tohitohi 19-05-2020 16 1   Download

The evaporation of I2 was observed to follow primarily first order kinetics, depending on the I2 concentration. The evaporation rate constant increased rapidly with increase in temperature. The presence of Ie slightly reduced the evaporation rate of I2 by forming relatively stable I 3 . The effect of Cle at

7p minhxaminhyeu4 26-06-2019 14 2   Download

. The effect of temperature on impact toughness was analyzed by the model and the trend of the simulation results was basicly consistent with the previous experimental results of CLAM steels. The load-displacement curve was simulated to express the low temperature ductile-brittle transition. The effect of grain size and inclusion was analyzed by the model, which was consistent with classical experiment results. The transgranular-intergranular transformation in brittle materials was also simulated.

7p minhxaminhyeu3 12-06-2019 32 1   Download