
Temperature effect
-
This study explores the effect of heating temperature on the ink transfer to Poly(vinyl chloride) and Poly(ethylene terephthalate) substrates in a specific retransfer printer. A notable correlation between heating temperature and solid color density was observed.
8p
viinuzuka
28-02-2025
1
1
Download
-
This paper investigates the integration of heat pumps for heating boiler feedwater and evaluates the impacts of feedwater temperature and condensate recovery rates on fuel consumption, energy efficiency, and CO2 emissions.
10p
viinuzuka
28-02-2025
1
1
Download
-
This study involved the deposition of NiO thin films onto Al2O3/glass substrates using RFmagnetron reactive sputtering. Then, the influence of heating temperatures on crystal structure, surface morphology, transmittance, and optical band gap of NiO films was investigated via different characterization techniques.
8p
tuetuebinhan000
23-01-2025
3
2
Download
-
Land use and land cover (LULC) change is a key factor influencing land surface temperature (LST) dynamics. This change reflects partly global warming and climate change at local and regional scales. This study aimed to evaluate the effect of LULC on LST change in Lac Duong mountainous district, Lam Dong province in the past 10 years (2013 - 2023), and predict the LST change in 2030.
16p
tuetuebinhan000
23-01-2025
4
2
Download
-
Lecture Sensors and analytical devices: Temperature measurement include all of the following: Thermoelectric effect sensors (thermocouples), varying resistance devices, semiconductor devices, radiation thermometers, thermography (thermal imaging), thermal expansion methods, quartz thermometers, fiber – optic temperature sensors,...
48p
youcanletgo_04
17-01-2016
44
4
Download
-
In this thesis, a numerical model with detailed reaction mechanism which is tailored for studying the behaviour of combustion of natural gas has been introduced and validated with available experimental data. The numerical model attempts to comprehensively simulate the physical conditions (temperature and pressure), equivalent ratio, and fuel dilution and strain rate effect in the laminar flames.
158p
runthenight05
01-03-2023
22
3
Download
-
The objective of this research is to identify potential impact on power generation in developed and developing countries. The study includes two case studies; a) power generation in a developing country and b) Power generation in a developed country. The study examines impact of climate change on power generation over a period of 100 years (2010-2100) in these two diverse countries.
147p
runthenight05
01-03-2023
6
3
Download
-
The proposed research aims to investigate the influences of temperature on the water retention behaviour of deformable unsaturated soil. Volume change caused by temperature variation will be taken into consideration. This research will produce a better understanding and interpretation of thermal effects on SWCCs by providing experimental results for deformable unsaturated soils.
118p
runthenight07
01-03-2023
6
3
Download
-
Municipal wastewater treatment plants generally utilise biological activated sludge processes to remove organic compounds and nitrogen. The biological nitrogen removal (BNR) occurs in two steps, nitrification (ammonium removal) and denitrification (nitrates removal). This study focused on a medium-sized wastewater treatment plant (WTP) which experienced poor nitrification for years, mainly when the weather temperature drops.
125p
runthenight07
01-03-2023
12
3
Download
-
In this Masters thesis computational modelling techniques were employed to investigate iron-free apo-Lactoferrin (apo-Lf) structural conformation changes in the presence of variant temperature and pH. These conditions represent the environment most milk protein goes through in food processing and the production of food products.
162p
runthenight04
02-02-2023
9
3
Download
-
This thesis has two key results, a study on the effect of carbon in electron-beam deposited platinum nano-wires and a novel temperature sensing glass substrate for marker-free thermometry. The thesis focus on the effect of carbon contamination in plasmonic nano-wires composed mainly of platinum produced from FEBID. Because carbon acts as an insulator in the platinum/carbon composite, we model the effect of carbon impurities by reducing the charge carrier concentration inthe platinumwire.
137p
runthenight04
02-02-2023
11
2
Download
-
The main aim of this investigation was to develop a low-cost solution to remove trace metals from the aqueous phase using biochar. This study investigated (i) the effect of giant reed-based biochar produced at varying temperatures in the treatment of aqueous solutions polluted with lead; and (ii) how the production of biochar at different temperatures affected its adsorption capacity for lead from the aqueous phase.
116p
runthenight04
02-02-2023
18
4
Download
-
Thermostable and highly water-soluble polymers are essential for polymer flooding — one of the most effective methods used in the enhanced oil recovery (EOR) in hightemperature (HT) offshore reservoirs. In this research, the copolymerization reaction of acrylamide (AM) and N-vinylpyrrolidone (NVP) monomers were performed via a freeradical mechanism induced by gamma-rays (γ-rays) irradiation.
79p
viabigailjohnson
10-06-2022
18
4
Download
-
Research purpose: to build an analytical model representing the cross Kerr nonlinear coefficient of a four-energy quantum system in the inverse Y configuration in the presence of the Doppler effect. Apply the analytical results to the case of 87Rb at room temperature. Studying the ability to control and enhance the cross Kerr nonlinearity according to the parameters of the associated laser field and the temperature of the environment.
26p
prisonbreak123
21-05-2021
23
4
Download
-
This process involves heating the oil to a temperature of 250OC in the presence of catalyst such as sulphuric acids, phosphoric acids, clays and metal oxides under an inert, atmospheric or vacuum condition.
11p
lucastanguyen
01-06-2020
14
3
Download
-
Anharmonic effective potential, local force constant and correlation effects in XAFS of BCC crystals
Analytical expressions for the anharmonic effective potential, local force constant, Displacement-displacement Correlation Function (DCF) CR and Debye-Waller factor described by the Mean Square Relative Displacement (MSRD) σ2 and by the Mean Square Displacement (MSD) u2of bcc crystals in the X-ray Absorption Fine Structure (XAFS) have been derived. The effective interatomic potential of the system has been considered by taking into account the influences of nearest atomic neighbors, and it contains the Morse potential characterizing the interaction of each pair of atoms.
8p
12120609
01-06-2020
17
2
Download
-
In this paper, we present a numerical analysis of the effect of different heat transfer correlations on the prediction of the cladding wall temperature in a supercritical water reactor at nominal operating conditions. The neutronics process with temperature feedback effects, the heat transfer in the fuel rod, and the thermal-hydraulics in the core were simulated with a three-pass core design.
11p
christabelhuynh
30-05-2020
24
1
Download
-
The objective of the present work is to study the irradiation effects on third generation SiC fibers which fulfill the minimum requisites for nuclear applications, i.e. Hi-Nicalon type S, hereafter HNS, and Tyranno SA3, hereafter TSA3. With this purpose, these fibers have been ion-irradiated with 4 MeV Au ions at room temperature and increasing fluences.
9p
christabelhuynh
31-05-2020
19
1
Download
-
An effective and expeditious method of the synthesis of a highly functionalized piperidines, catalyzed by nontoxic, recyclable and environment friendly sodium lauryl sulfate (SLS), via one-pot multi-component condensation of aldehydes, amines and β-ketoesters in water at room temperature, has been developed.
8p
tocectocec
25-05-2020
12
3
Download
-
The low cycle fatigue (LCF) resistance of two different metal matrix composite (MMC) of AA6063 with 2% and 8% by volume silicon carbide (SiCp) particles having particulate size of 37 micron (400 mesh) at room temperature condition has been evaluated under fully reversed strain control testing.
15p
tohitohi
19-05-2020
24
1
Download